올라이트라이프

ASD532

Aspirating smoke detectors

Type	DC24V, standard, restorable, analog, detection concentration range (1%/m-10%/m), air suction input 1, air pipe maximum working distance 70m
Type approval No	감19-13
Ambient temperature	-20~60ºC
Ambient Voltage	14.0-30 VDC (EN54) 16.4~27 VDC(FM/UL)
Low-noise	24.5~39dBA
Dimensions	195 X 140 X 290(mm) (W x D x H)
Weight	1950g
Air distribution pressure	180Pa
Sensitivity range	1%/m~10%/m
Relative humidity	10~85%
Max air pipe connection length	70m
Protection rating	IP54
Material	ABS b lend, UL 94-V 0
Simulation programing	PipeFlow
Fire safety standard	NFSC203 Article 7

ASD535-3

Aspirating smoke detectors

Type	DC24V, standard, restorable, analog, detection concentration range (1%/m-10%/m), aspirating input 4, air pipe maximum working distance 600m, Maximum operating distance per aspirating input 150m
Type approval No	감19-14
Ambient temperature	-30~60ºC
Ambient Voltage	10.5-30 VDC (EN54) 12.4~27 VDC(FM/UL)
Low-noise	32~42dBA
Dimensions	263 X 148 X 348(mm) (W x D x H)
Air distribution pressure	420Pa
Sensitivity range	1%/m~10%/m
Relative humidity	10~85%
Max air pipe connection length	600m
Protection rating	IP54
Material	ABS b lend, UL 94-V 0
Simulation programing	PipeFlow
Fire safety standard	NFSC203 Article 7

ASD535-4

Aspirating Smoke Detector

Type	DC24V, Nomal Type, Restorable Type, Air Sampling Type, Analog Type, Range of nominal detection concentraion,(1%/m~10%/m), Four inlet pipes, Maximum pipe lengh depending on number of inlets :(One: 150m, Two : 140m Three : 130m Four : 125m), model :ASD 535-4
Type approval No	감24-29
Ambient temperature	-30~60ºC
Ambient Voltage	10.5-30 VDC (EN54) 12.4~27 VDC(FM/UL)
Low-noise	32~42dBA
Dimensions	263 X 148 X 348(mm) (W x D x H)
Air distribution pressure	420Pa
Sensitivity range	1%/m~10%/m
Relative humidity	10~85%
Max air pipe connection length	600m
Protection rating	IP54
Material	ABS b lend, UL 94-V 0
Simulation programing	PipeFlow
Fire safety standard	NFSC203 Article 7

16-62

Wireless photoelectric spot detector

Product view

Type	DC3V, 2 type, standard, restorable, address type, wireless
Type name	all_ASD_RF_6000
Rated Voltage	DC 3 V
Ambient Temperature & Humidity	(temperature) : -10 ~ 50℃/ (humidity) :10 ~ 95%
Current consumption	20mA at fire detection
Sensing mode	Scattered light detection by smoke with 15% photosensitive rate
Color and weight	Ivory white / 120g

16-62

Wireless fixed temperature spot detector

Type	DC3V, 1 type, standard, restorable, address type, wireless
Type name	all_AFT_RF_6000
Rated Voltage	DC 3 V
Ambient Temperature & Humidity	(temperature) : -10~50℃ / (humidity) : 10~95℃
Current consumption	20mA at fire detection
Sensing mode	Nominal working temperature point detection by semiconductor
Color and weight	Ivory white/140g

Linear detection system(fiber optic cable)

Optical sensor repeater
Type	AC220V, DC24V, semiconductor, R, input 254 circuit
Type approval No	중17-2, 중17-14
Ambient Temperature	-10~50℃
Relative humidity	RH 10~85%
Ambient Voltage	AC 220V ± 20%
Auxiliary power	DC 24V/4Ah (DC12V/4Ah(*seconds) Lead acid battery
Dimensions	567㎜ * 464 ㎜ * 646 ㎜ (W*D*H)
Material	1.6t STEEL
Boundary zone	254 circuit
Fire safety standard	NFSC203 Article 6

Fixed temperature Line type heat detector
Type	Fixed temperature Line type heat detector analog, sensing temperature range (30 ℃~80 ℃), standard, restorable, waterproof, fiber optical cable
Type approval No	감 16-22
Ambient Temperature	-30ºC~90ºC
Relative humidity	RH 0~100%
Dimensions	1.8mm(O.D)
Maximum installation length	4Km
Weight	30kg/4km
Material	STS304
Fire safety standard	NFSC203 Article 7

Differential distributed detector
Type	Rate of rise heat detector type 1, standard, restorable, waterproof, Fiber optic cable
Type approval No	감 16-62
Ambient Temperature	-30ºC~90ºC
Relative humidity	RH 0~100%
Dimensions	1.8mm(O.D)
Maximum installation length	4Km
Weight	30kg/4km
Material	STS304
Fire safety standard	NFSC203 Article 7

16-62

Differential distributed detector

Type	Differential distributed detector type 1, standard, restorable, waterproof, fiber optic cable
Ambient Temperature	-30ºC~90ºC
Relative humidity	RH 0~100%
Dimensions	1.8mm(O.D)
Maximum installation length	4Km
Material	STS304

Flame detector

Product view

Type	DC24V, standard, restorable, waterproof, indoor and outdoor, ultraviolet infrared hybrid type, viewing angle 100, effective detection distance 30/50m
Type approval No	감 19-17
Ambient Temperature & Humidity	temperature(-40ºC~+75ºC), storage temperature(-50ºC~+90ºC), humidity(10%~90%)
Power consumption	3W
Ambient Voltage	DC 24V(18~30V)
Current consumption	- Normal Status (Supervise fire) : 30mA - Alarm Status (Alarm fire) : 100mA - Inrush current : 1A”

SCU-800/16

Line type heat detector system (semiconductor)

Line type heat detector system
Ambient temperature	-10ºC~60ºC
Dimensions	W260 X H150 X D90
Power supple	DC 21~29V
Enclosure material	Aluminum
Waterproof dustproof rating	IP65
Weight	2.4kg
Power consumption (normal state)	2.7W
Relay	16 X contact setting possible (Alarm, pre-alarm, error / 1 X fault contact
Relay contact load	DC 48V / AC 32V / 250mA max.
Reset input	DS 5V(Galvanic separation)
Interface	RS-232(Programming) RS-485(Networking and remote display unit connection)
Certification	:German Insurance Association (VdS Approval - G205143)

Line type heat detector system sensor cable
Standard sensor distance	1m, 2m, 3m, 4m, 5m (Onsite custom available 0.25-10m)
Maximum cable length	2 X 250m (Including connection cable)
Maximum No of sensors	2 X 99
Temperature measurement range	-40ºC~+120ºC
Continuous working temperature	-40ºC~+85ºC
Short-term working temperature	+120ºC
Cable sheath material	Halogen-free, fire retardant material (Reference EN 60332-1-2, 2-2, IEC 60754-1)
Cable thickness	apprax. 15 mm
Weight (per 1 m)	0.35 kg/m
Color	Grey
Minimum bending radius	0.25m
Installation temperature	>+10ºC

Water monitoring system

인터페이스 키트(방재실)

Input power	DC 24V
정격전류	Max 5A
최대 수용 GATEWAY 수	127개 X 2계통 필요시 확장 가능 : 최대 16계통

Water monitoring system

Pressure sensor (alarm valve room)

Input power	DC 9V ~ 30V
Current consumption	Less than 30mA
Pressure monitoring signal	4~20mA
Pressure sensing range	0~100 Bar G

Arc monitoring system

Serial arc current detection	Over 0.2 within 0.2 sec
Parallel arc current detection	Over 1A 0.5sec
Alarm by stage	Total 4 stages
	Suitable for FIS015(arc alarm performance certification Suitable for UL1699(AFCI)

Wireless GR Type Fire Alarm Control Panel

Product view

Type	AC220V, DC 24V, LCD, analog, storage/nonstorage(Indoor outdoor fire hydrant, sprinkler) equipment, (water spray, foam) extinguishing equipment, smoke control equipment
Type approval No	수 19-57
Storage time	10-60 seconds
Rated Voltage	AC220V, DC24V
Connectable fire alarm bell quantity	DC24V 50mA X 20EA
Connectable transmitter	발12-1
Connectable addressable module	중18-18, 중18-19, 중18-20
Auxiliary power	DC12V, 4Ah X 2EA(Lead acid battery)
Maximum Quantities for One Loop	(Wireless 24 + Wired 424) /per system
No of lines for wired	508/ system
No of lines for wireless	20/ system
Maximum address	127/system

Wireless Addressable Module

Product view

Type	DC24V, GR type, wireless input 20 Circuit, wired input 4Circuit, wired output 4Circuit, Wire · wireless
Type approval No	중19-40
Output capacity	DC 24V, 1A
Maximum quantity of connectable wireless detector	20
Main power Rated Input Power	24V
Output capacity	1A
KC ID	R-CS rP3-all-RF44-1
Connectable Control Panel	수19-57
Connectable Detector

ALLSE-ASD-4

Aspirating Smoke Detector

Model NO	Allse-ASD-4
Number of channel	4 channel
Operating Temperature	-10 ~ 50ºC (Operates normally inminus temperature during winter)
Test Temperature	-10 ~ 50ºC
Operating Humidity	RH 10 ~ 85%
Size	Body : 370(W) x 273(H) x 137(D) box : 370(W) x 365(H) x 137(D)
Weight	3,470g (Body) 3,940g (When installing filter box)
Maximum Suction Pressure	410 Pa
Number of pipes	1 to 4 pipe (2 Monitoring Chamber)
Input Voltage	DC 24V (± 10 %)
Protected Area	5,760m2
Single Pipe Length	150m
Maximum Pipe Length	600m
Sensitivity Range	0.02 ~ 10%/m (UL)
FACPCommunication Connection	RS 485 •Status check: Detection concentration / Pre-Alarm / Fire Alarm/ ChannelCommunication Error •Fire Recovery Function •Detection Concentration Setting: Pre-alarm, Fire Alarm •Sensor Selection Function
Material	PC/ABS BLEND< UL94-V0,5VB
Manufacturer Inspection	Factory inspection available (domestic)

ASD-ALE

Aspirating Smoke Detector

Model NO	ASD-ALE
Number of channel	4 channel
Operating Temperature	-10 ~ 50ºC (Operates normally inminus temperature during winter)
Test Temperature	-10 ~ 50ºC
Operating Humidity	RH 10 ~ 85%
Size	Body : 370(W) x 273(H) x 137(D) box : 370(W) x365(H) x 137(D)
Weight	3,470g (Body) 3,940g (When installing filter box)
Maximum Suction Pressure	410 Pa
Number of pipes	1 to 4 pipe (2 Monitoring Chamber)
Input Voltage	DC 24V (± 10 %)
Protected Area	5,760m2
Single Pipe Length	150m
Maximum Pipe Length	600m
Sensitivity Range	1~20 %/m (KFI)
FACPCommunication Connection	RS 485 •Status check: Detection concentration / Pre-Alarm / Fire Alarm/ ChannelCommunication Error •Fire Recovery Function •Detection Concentration Setting: Pre-alarm, Fire Alarm •Sensor Selection Function
Material	PC/ABS BLEND< UL94-V0,5VB
Manufacturer Inspection	Factory inspection available (domestic)

ALLSE-ASD-1

Aspirating Smoke Detector

Model NO	Allse-ASD-1
Number of channel	1 channel
Operating Temperature	-10 ~ 50ºC
Test Temperature	-10 ~ 50ºC
Operating Humidity	RH 10 ~ 85%
Size	120(W) x 105(H) x 195(D)
Maximum Suction Pressure	120 Pa
Number of pipes	1 pipe (1 Monitoring Chamber)
Input Voltage	DC 24V (± 10 %)
Protected Area	1,280 m2
Single Pipe Length	70 m
Sensitivity Range	0.02 ~ 10%/m
Material	PC/ABS BLEND< UL94-V0,5VB
Manufacturer Inspection	Factory inspection available (domestic)